Starting/Stopping The Mower; Mowing Tips - GreenWorks Tools 2505107 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
■ To lower the blade height, grasp the height adjustment
lever and move it toward the front of the mower.
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
Always wear eye protection. Failure to do so could
result in objects being thrown into your eyes resulting
in possible serious injury.
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
Always inspect mower for missing or damaged parts
and blade for damage, uneven, or excessive wear prior
to use. Using a product with damaged or missing parts
could result in serious personal injury.
■ Do not tilt the lawn mower when starting the engine
or switching on the motor, unless the lawn mower has
to be tilted for starting. In this case, do not tilt it more
than absolutely necessary and lift only the part which
is away from the operator.
■ Do not start the engine when standing in front of the
discharge chute.
■ Do not put hands or feet near or under rotating parts.
Always keep clear of the discharge opening.

STARTING/STOPPING THE MOWER

See figure 6.
To start the motor:
■ Plug the mower into an approved outdoor extension
cord.
■ Press and hold the start button.
■ Pull the switch box handle upward to the handle to
start the mower and release the button.
English (Original Instructions)
WARNING
WARNING
WARNING
WARNING
To stop the motor:
EION
■ Release the switch box handle.
The protector (it's a device that is calibrated to open the
motor circuit upon reaching a certain temperature/current
but requires both cool down below the calibration point
and removal of power for resetting of the protector) in
the mower helps to stop the mower if blade is stuck or
overload occurs.
When the protection happens, the operator should release
the bail switch and pull the plug immediately, then restart
the mower after at least 1 minute. The operator will wait
for longer time and the mower can't run if it is restarted
within 1 minute.

MOWING TIPS

■ Make sure the lawn is clear of stones, sticks, wires,
and other objects that could damage the lawn mower
blade or motor. Do not mow over property stakes or
other metal posts. Such objects could be accidentally
thrown by the mower in any direction and cause
serious personal injury to the operator and others.
■ For a healthy lawn, always cut off one-third or less of
the total length of the grass.
■ Do not cut wet grass, it will stick to the underside of
the deck and prevent proper bagging or mulching of
grass clippings.
■ New or thick grass may require a narrower cut or a
higher cutting height.
■ Clean the underside of the mower deck after each use
to remove grass clippings, leaves, dirt, and any other
accumulated debris.
■ When cutting long grass, reduce walking speed to
allow for more effective cutting and a proper discharge
of the clippings.
NOTE: Always stop mower, allow blade to completely
stop, and remove the isolator key before cleaning
underneath the mower.
USING THE CORD RETAINER
See figure 7.
This lawn mower is equipped with a cord retainer in order
to prevent the extension cord from disconnecting from the
power cord while the mower is in use. The cord retainer
hangs from the cord guide bar.
NOTE: Do not plug the extension cord into the outlet until
it has been connected to the cord retainer and plugged
into the mower.
To use the cord retainer:
3

Publicité

Table des Matières
loading

Table des Matières