Programming A User Code - Wittkopp Multicode Manuel D'utilisation

2. Master and user codes
2.1 changing the master or user code
After entering the new code, the electronic lock should be opened and locked several times with the safe
door opened.
Step
Press and hold the key '0' until the red LEDs flash permanently
1.
Enter code e.g. factory code 1234567
2.
Enter your new 7-digit code e.g. 5678913
3.
Re-enter your new 7-digit code e.g. 5678913
4.

2.2 Programming a user code

The master is able to program a user code, but not vice versa.
Step
Press and hold the key '1' until the red LEDs flash permanently
1.
Enter your 7-digit master code e.g. 5678913
2.
Enter the user PIN e.g. user 5
3.
Enter the new 7-digit user code e.g. 1111111
4.
Enter the new 7-digit user code e.g. 1111111
5.
• A new user code will be allowed only if the code is differing in two places by a single digit from an existing
code. If the user code is not accepted, you will hear a long signal.
• If an opening delay is programmed, user 9 for instant opening code (if it has not been programmed yet) can
only be programmed during the release window (more information 3.4).
2.3 deleting a user
The master is able to delete a user, but not vice versa.
Step
Press and hold the key '3' until the red LEDs flash permanently
1.
Enter your 7-digit master code e.g. 5678913
2.
Enter the user PIN of the user who has to be deleted e.g. user 1.
3.
2.4 operation blocking
Only the master can enable or disable all user codes at the same time.
Have user codes been disabled, the lock can be opened only with the master code.
Step
Press and hold the key '2' until the red LEDs flash permanently
1.
Enter your 7-digit master code e.g. 5678913
2.
think safe
Action
Action
Action
Action
Key
0
1234567
5678913
5678913
Key
1
5678913
5
1111111
1111111
Key
3
5678913
1
Key
2
5678913
15