Ibx LBX OVF Force Air Drying Oven Mode D'emploi page 9

Parameter list-2:
Parameter
Name
indicator
Lc- Password
Turn off the heat
Co-
output deviation
Constant
Hn-
temperature time
End of operation
En-
temperature
Maximum power
Lt-
output
Gate-control
oP-
function
7. Fault resolution
▪
The equipment cannot be turned ON
-Make sure the cable is rightly connected.
▪
The temperature cannot reach the set point
-Check if the temperature is set too low and readjust it.
-Check for apparent damages that may have arisen during transportation.
-The heater and/or the electric system may be damaged.
If these faults are not resolved, contact your manufacturer/supplier
8. Maintenance
▪ Proper maintenance can keep instruments working properly and lengthen its lifetime.
▪ Do not spray cleanser into the instrument when cleaning. Avoid cleaning it with chemical solutions to prevent reaction
damage.
▪ Unplug the power line while cleaning.
▪ Wear the proper protective gloves during cleaning procedures.
▪ The device needs to be cleaned and decontaminated before sending to repair.
▪ Must be sent with the original packing.
Make sure the device is used on a clean and dry surface and that the ambient temperature is steady.
▪
When Lc=0009,then we can see and modify parameters
When"PV≥SP+Co"，Turn off the heating output
0：minutes time；1：hours time
mode
When EN = 0, when the run time is over, the SV window will display "End",
the buzzer will make a sound for 30 seconds and the heater is
disconnected
When EN = 1, when the run time is over, the SV window does not
show "End", the buzzer will make a sound for 30 seconds and the
heater will continue at constant temperature
The heating output maximum power percentage
0: shut-off function of opening door to judge, 1: unlock function of
opening door to judge
Instruction of the Parameter's function
9
(Setting range)
default set value
0
(0.0～50.0℃)
5.0
(0～1) 0
(0～1) 0
(0～100)100
(0～1) 1