Timer Setting; Temperature Alarm - Ibx LBX OVF Force Air Drying Oven Mode D'emploi

6.2 Timer setting

By default, this feature will be OFF. Therefore, the equipment will keep working until it is manually switched OFF.
▪ Press the SET button. The controller will run into temperature setting state. Press the SET button again, the controller will
run into time setting state.
▪ In the time setting state, use the "▼" and "▲" buttons to select the desired time value (1-9999 min). Use the "◄"
button to go from one digit to the next. Press the SET button again, it will quit the setting state and the settings
will be saved automatically.
▪ When the temperature reaches the value set at 6.1, the timer will start. When the run time is over, the SV window
will display "End", the buzzer will make a sound for 30 seconds and the heating will be disconnected.
▪ In order to stop the buzzer sound, you can press any button from the controller.
▪ In order to switch OFF this feature, you can set the desired time value to 0000 min.

6.3 Temperature alarm

▪ The alarm is set by default at 5ºC.
▪ This means that when the working temperature is 5ºC higher than the desired temperature, the alarm will activate.
▪ When the temperature alarm activates, the buzzer sounds and "ALM" lights. To stop the sound, you can
press any button.
▪ If a 5ºC over-temperature is reached by changing manually the temperature value (6.1), "ALM" lights but
the buzzer does not sound.
6.4 Other concerns
▪ In the setting state, the controller will return to run status if no key is pressed in one minute.
▪ If the display window shows "----", it indicates the fault of temperature.
7