Trial Run; Operating - Ibx LBX OVF Force Air Drying Oven Mode D'emploi

5. Trial run

▪ Unwrap the equipment and, without connecting the equipment to the net, make sure that it does not present any
damage. In case the equipment presents any damage, communicate it immediately your transport agent or
dealer.
▪ Place the equipment on a flat, stable surface that can support the weight of the device leaving 30 free cm on
each side.
▪ Make sure the required operating voltage and the power supply's voltage match.
▪ Make sure the socket is earthed.
▪ Switch the power button ON.
▪ The PV screen will display the real temperature of the working room. The SV screen will display the previously
set temperature.
▪ Press the SET button and set a higher temperature (as shown in 6.1). If the temperature increases, the equipment
is working properly.
▪ Switch the power button OFF to turn off the oven.

6. Operating

▪ Place the equipment on a flat, stable surface that can support the weight of the device leaving 30 free cm on
each side.
▪ Place the sample in the container (advice: the size of the sample should not be over 2/3 of the shelf); then close the
container door.
▪ Turn the power button ON and then turn the fan button ON.
▪ The PV screen will display the real temperature of the working room while the SV screen displays the previously
set temperature.
▪ After usage, turn off the equipment by pressing the Power ON/OFF switch and unplug it.
6.1 Set the working temperature
The max working temperature is 300ºC, set the temperature this way:
▪ Press the SET button. The controller will run into temperature setting state.
▪ In the temperature setting state, use the "▼" and "▲" buttons to select the desired temperature value. Use the "◄"
button to go from one digit to the next. Press the SET button again twice, it will quit the setting state and the
settings will be saved automatically.
▪ Temperature will start to rise until the working room reaches the desired temperature value.
▪ The PV screen will display the real temperature of the working room while the SV screen displays the previously
set temperature.
Note: don't close the fan when the temperature is rising, or else it will accelerate the ageing of the
heater.
6