Before Installation; Scope Of Delivery; Assemble Device - AEG CTV 1902 Manuel D'utilisation

ENGLISH
56
CAUTION:
• Do not use odd battery types or fresh and exhausted batteries.
• Do not dispose of batteries with the household trash. Return exhausted batteries to collection points or your dealer.
NOTE:
• If the remote control range shortens the batteries are exhausted and must be replaced.
• Do not use rechargeable batteries.
• Protect batteries from heat and direct sunlight. Do not dispose of batteries by burning, danger of explosion!
• Remove exhausted batteries from the device. Remove the batteries during longer periods of non-use to avoid bat-
tery leakage.
• Wash thoroughly after coming into contact with battery acid.

4. Before Installation

4.1 Scope of Delivery

After unpacking ensure that the following parts were included:
• TV set
• Stand base plate and three Phillips screws
• Remote control (incl. 2 x 1.5 V batteries type LR03 AAA)
• User manual

4.2 Assemble Device

• Mount the base plate onto the stand. Manually secure the screw to the base.
• Attach the stand with the three Phillips screws.
• Remove the protective film from remote control and TV set, if attached.
• Place the TV set on a stable, level surface. Ensure that the surface can carry the TV's weight.
• Protect the device from extreme heat and humidity.
• Ensure sufficient ventilation on all sides. When placed in a wall unit leave at least 20 cm on top and 10 cm distance at
the sides for ventilation.
NOTE: Wall mounting
• You can alternatively mount the device with the help of a suitable VESA standard wall bracket (available from dea-
lers) to a suitable wall.
- Gap between holes in millimeters: 100 x 100.
- Thread: M4. The pitch length of the screws may not exceed 10 mm.
• The stand is not fitted when mounting to a wall.
• Maintain a clearance of at least 8 cm for ventilation around the device.
• Check the reach of the cable! When mounting the device, make sure that an easily accessible outlet is available
within reach of the power cable.