Samsung NE59M6850 Série Mode D'emploi page 53

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
Possible cause
The oven will
The oven temperature is
not self-clean.
too high to start a self-clean
operation.
The oven controls have been
set incorrectly.
A self-cleaning cycle cannot
be started if the oven lockout
feature has been activated or
if a radiant surface element
is on.
Excessive
There is excessive soiling in
smoking during
the oven.
a self-cleaning
cycle.
The oven door
The oven is too hot.
will not open
after a self-
cleaning cycle.
The oven is not
The oven controls were not
clean after a
set correctly.
self-cleaning
The oven was heavily soiled.
cycle.
NE59M6850SS_AA_DG68-00883A-00_EN+MES+CFR.indb 53
Solution
Allow the range to cool and
Steam is
then reset the controls.
coming out of
the vent.
See the section on self-
cleaning on page 43.
Release the oven lockout (see
page 42). Make sure all
surface elements are turned
off.
A burning or
oily odor is
coming from
Press OVEN OFF. Open the
the vent.
windows to rid the room of
smoke. Wait until the self-
cleaning cycle is canceled and
Strong odor.
the oven is cool. Wipe up the
excessive soil and then start
the self-cleaning cycle again.
Allow the oven to cool.
Fan noise.
Oven racks
See the section on self-
are difficult to
cleaning on page 43.
slide.
Wipe up heavy spillovers
before starting the self-
cleaning cycle. Heavily soiled
ovens may need to be self-
cleaned again or for a longer
period of time.
Problem
Possible cause
When using the convection
feature, it is normal to see
steam coming out of the oven
vent.
As the number of racks or
amount of food being cooked
increases, the amount of
visible steam will increase.
This is normal in a new oven
and will disappear in time.
An odor coming from the
insulation around the inside
of the oven is normal for the
first few times the oven is
used.
A convection fan may
automatically turn on and off.
The shiny, silver-colored
racks were cleaned in a self-
cleaning cycle.
Solution
This is not a system failure
but normal operation.
To speed the process, set
a self-cleaning cycle for a
minimum of 3 hours.
See the section on self-
cleaning on page 43.
Operate the oven at the bake
setting at 400 °F for 1 hour.
This is not a system failure
but normal operation.
Apply a small amount of
vegetable oil to a paper towel
and wipe the edges of the
oven racks with the paper
towel.
English 53
2/10/2017 4:37:46 PM

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ne59m6850ss/aa-00Ne59m6850sg/aa-00

Table des Matières