Handling The Remote Controller - Carrier RG66B3 Manuel Du Propriétaire

HANDLING THE REMOTE CONTROLLER

NOT SURE WHAT A FUNCTION DOES?
How to Use Basic Functions
Refer to the
How to Use Advanced Functions
this manual for a detailed description of how to
use your air conditioner.
SPECIAL NOTE
● Button designs on your unit may differ
slightly from the example shown.
● If the indoor unit does not have a particular
function, pressing that function's button on
the remote control will have no effect.
INSERTING AND REPLACING BATTERIES
Your air conditioning unit comes with two
AAA batteries. Put the batteries in the remote
control before use:
1. Remove the back cover from the remote
control, exposing the battery compartment.
2. Insert the batteries, paying attention
to match up the (+) and (-) ends of the
batteries with the symbols inside the battery
compartment.
3. Install the back cover on.
INSTALLING REMOTE CONTROL HOLDER
The remote controller can be attached to a wall
or stand by using a remote controller holder
(optional part, not supplied with the unit).
1. Before installing the remote controller, check
that the air conditioner receives the signals
properly.
2. Install the holder with two screws.
3. Put the remote controller in the holder.
BATTERY NOTES
For optimum product performance:
● Do not mix old and new batteries, or
batteries of different types.
● Do not leave batteries in the remote control
if you don't plan on using the device for
more than 2 months.
BATTERY DISPOSAL
Do not dispose of batteries as unsorted
municipal waste. Refer to local laws for proper
disposal of batteries.
TIPS FOR USING REMOTE CONTROL
and
● The remote control must be used within 8
sections of
meters of the unit.
● The unit will beep when remote signal is
received.
● Curtains, other materials and direct
sunlight can interfere with the infrared
signal receiver.
● Remove batteries if the remote control will
not be used more than 2 months.
● Prevent any liquid from falling into the
remote controller.
● If other electrical appliances react to
the remote controller, either move these
appliances or consult your local dealer.
4
Remove the back cover to
install batteries
Put the remote controller in
the holder.