How To Use The Advanced Functions; Silence Function - Carrier RG66B3 Manuel Du Propriétaire

How To Use The Advanced Functions
ECO function
NOTE:
This function is only available under
COOL mode.
● Used to enter the energy efficient mode.
● Under cooling mode, press this button, the
remote controller will adjust the temperature
automatically to 24 °C, fan speed of Auto to
save energy (but only if the set temperature
is less than 24 °C). If the set temperature
is above 24 °C, press the ECO button,
the fan speed will change to Auto, the set
temperature will remain unchanged.
NOTE:
● Pressing the ECO button, or modifying the
mode or adjusting the set temperature to
less than 24 °C will stop ECO operation.
● Under ECO operation, the set temperature
should be 24 °C or more. it may result
in insufficient cooling. If you feel
uncomfortable, just press the ECO button
again to stop it.
SLEEP Function
The SLEEP function is used to decrease
energy use while you sleep (and don't
need the same temperature settings to stay
comfortable). This function can only be
activated via remote control. For the detail, see
"sleep operation" in "USER'S MANUAL".
NOTE: The SLEEP function is not available
in FAN or DRY mode. Press ON/OFF, MODE,
FAN, TURBO, SELF CLEAN or ECO button will
stop sleep operation.
FOLLOW ME function
The Follow me function enables the remote
control to measure the temperature at its
current location and send this signal to the
air conditioner every 3 minutes interval.
When using AUTO, COOL, or HEAT modes,
measuring ambient temperature from the
remote control (instead of from the indoor unit
itself) will enable the air conditioner to optimize
the temperature around you and ensure
maximum comfort.

Silence function

Hold down Fan speed button for 2 seconds
to activate/cancel
frequency operation of compressor, it may
result in insufficient cooling and heating
capacity. (applicable to the air conditioner
with Silent feature only)
Mode ON/OFF Fan
Timer Timer
Follow
LED
me
Self
Turbo
clean
8 °C Heating Function
When the air conditioner operates under
heating mode with the set temperature
of 16 °C, press Temp
one second will activate 8 Degree heating
function. The unit will operate at a setting
temperature of 8 °C. The indoor unit display
shows "FP". For some units, press this button
can activate 12 °C heating feature, please
refer to the "Owner's Manual" of the air
conditioner.
13
Silent
mode. Due to low
Hold down Fan
button for 2 seconds
to activate Silence
function
Press this button
twice in one second
to activate 8 °C
heating function
Hold down Eco
button for 2 seconds
to activate/cancel
SLEEP function
–
button twice in