Zelmer SYRIUS Mode D'emploi page 20

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Do not hold the working turbobrush for a longer
time in one place, but constantly move it, so as
not to damage the carpet (fitted carpet).
While cleaning carpet fringes always move the
turbobrush in the direction indicated by the
arrow (Fig.
). It prevents getting the fringes
H
into the rotating brush.
The speed of the brush roller rotation depends
on the amount of dust in the dust bag and
cleanliness of filters. The roller may stop
rotating on the carpet. Then the dust bag and
filters should be replaced.
Maintenance and cleaning of the turbobrush
Before cleaning and maintenance of the
turbobrush it must be disassembled from the
vacuum cleaner.
Cleaning of the rotating brush
During operation the brush collects pieces of:
threads, strings, hair, rags, etc. They reduce
cleaning efficiency.
To remove dirt from the rotating brush follow the steps below:
1 Place tips of scissors into the slot of the rotating brush.
2 Move the scissors so as to catch the threads and hair
tangled on the brush.
3 Cut them and take out manually or using small tongs.
Be careful not to damage the bristle of the rotating brush.
Dirt such as matches, pieces of paper or
clothing may obstruct the suction duct of the
turbobrush, leading to significant reduction of
the suction power and reduced speed or brush
roller rotation (until it completely stops).
Cleaning of the suction duct of
the turbobrush
To remove dirt from the suction duct of the turbobrush follow
the steps below:
1 Turn the turbobrush with wheels upward.
2 Press the fastening in the turbine cover and take the
cover out from the turbobrush.
3 Remove dirt from the suction duct, turbine blades and
turbine chamber.
4 Place the turbine cover so that its two ledges match
the holes in the turbobrush body, press the cover until the it
latches on the body. Characteristic clicking sound indicates
the correct assembly of the turbine cover.
20
Cleaning the turbobrush
Never clean the turbobrush with gasoline,
solvents, oils and other chemicals that may
cause discoloring of the housing.
Do not use granular cleaning agents that may
scratch the housing.
The turbobrush may be cleaned with damp cloth
(possibly moisten with a washing-up liquid).
Store the turbobrush away from hot ovens,
radiators, heaters, etc. High temperature
may lead to permanent deformation of the
turbobrush housing.
I
J
1600-018_v01

Publicité

Table des Matières
loading

Produits Connexes pour Zelmer SYRIUS

Ce manuel est également adapté pour:

1600.0st

Table des Matières