Zelmer SYRIUS Mode D'emploi page 15

Do not use to pick up flammable or
●
combustible liquids such as gasoline
or use in areas when they may be
present.
Hold plug when rewinding onto
●
cord reel. Do not allow plug to whip
rewinding.
Unplug before connecting any hose
●
attachment accessory.
Before cleaning and maintenance of
●
the turbobrush it must be disassembled
from the vacuum cleaner.
Always unplug the appliance before
●
cleaning, assembling or dismantling.
Use extra care when cleaning on
●
stairs.
Turn off all controls before unplugging.
●
Do not use without filters in place.
●
Avoid using in vertical position.
●
Save these instructions
This vacuum cleaner is intended for
household use only.
CAUTION (For USA and CANADA only)
To reduce the risk of electric shock this
appliance has a polarized plug (one
blade is wider than the othe).
This plug will fit in a polarized outlet
only one way. If plug does not fit fully in
the outlet, reverse the plug.
If it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
The manufacturer of the vacuum
cleaner is not responsible for possible
consequences if the vacuum cleaner is
used not according to its purpose or if it
is not operated properly.
1600-018_v01
The manufacturer reserves the right
to change the product without notice
in case it has to conform to legal
rules, standards, directives or for the
construction, commercial, esthetic and
other reasons.
Static electricity
In the process of vacuuming of some surfaces in areas of
low air humidity the device may become electrically charged.
It is a natural phenomenon – it does not damage the device,
and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend you to:
●
discharge the device by touching metal items in the room
with the pipe,
●
increase air humidity in the room,
●
use widely available antistatic agents.
Appliance elements
ON/OFF button
1
Handle
2
Cord rewind button
3
4 Combination brush fastening
Accessory compartment cover
5
6 Plug and cord
Outlet filter cover
7
8 Filter wear indicator
Power increase button
9
Suction power level indicator
10
Power decrease button
11
Dust bag full indicator
12
13 Front cover fastening
Suction hose
14
15 Outlet filter HEPA H11 (installed in the vacuum cleaner)
Inlet filter (installed in the vacuum cleaner)
16
SAFBAG dust bag (1 piece, (installed in the vacuum
17
cleaner)
18 Telescopic suction tube
Small brush
19
20 Crevice nozzle
Small nozzle
21
Turbobrush
22
Combination brush with a small item separator
23
Parquet brush "BNB"
24
Is used to clean and polish hard, scratch sensitive
surfaces such as wooden floors, floor panels, parquet,
marble, tiles, etc.
Delicate and soft natural bristles ensure maximum
vacuum effectiveness and protects against scratching
the cleaned surface.
A
15