Fellowes POWERSHRED 225Ci Mode D'emploi page 4

Masquer les pouces Voir aussi pour POWERSHRED 225Ci:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
2
AUTO
Turn off and unplug
Locate Auto-start
shredder
infared sensor
OILING SHREDDER
All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive
noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
AUTO
AUTO
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PREvENTIvE MAINTENANCE & ACCESSORIES
TROUBLESHOOTING
A
B
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
.
3
4
AUTO
AUTO
Dip cotton swab in
Using cotton swab, wipe
rubbing alcohol
away any contamination
from the paper sensors
C
D
15
A. Door Open Indicator: The shredder will not run if the cabinet door is open. When illuminated, close the
door to resume shredding.
B. Bin Full Indicator: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes
waste bag 36054.
C. Remove Paper Indicator: When illuminated, press reverse (
Reduce paper quantity to an acceptable amount and refeed into paper entry.
Indicator: If hands are too close to the paper entry, the SafeSense
D. SafeSense
®
and the shredder will stop shredding. If SafeSense
turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (225Ci only).
ENGLISH
Models 225Ci/225i
) and remove paper.
indicator will illuminate
®
is active for 3 seconds, the shredder will automatically
®
4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Powershred 225i

Table des Matières