Replacing The Battery - IMG STAGELINE SOUND-4BT/WS Mode D'emploi

– AUX 2: line signal level input via a
3.5 mm stereo jack
– AUX 1: line signal level input via RCA
jacks (left L /right R)
3) The stereo input signal is internally mixed
to a mono signal for the output SUB OUT
(3). An active subwoofer system or a dif-
ferent unit equipped with a line input can
be connected to this RCA jack.
4) First connect the mains cable supplied
to the mains jack (6) and then connect
the mains plug of the cable to a socket
(230 V~ / 50 Hz).
5 Remote Control
The remote control is supplied with a battery.
Prior to initial operation, remove the protec-
tive film from the battery support. When
pressing a button, always point the remote
control to the window (1) of the active
speaker system . Make sure that there are no
obstacles between the window and the
remote control.
If the remote control is not used for a
longer time, remove the battery as a precau-
tion so that the remote control will not be
damaged in case the battery should leak.

5.1 Replacing the battery

1) Push the latch of the battery support to the
right (first arrow in figure 5) and pull out the
support (second arrow).

2) Remove the discharged battery and insert
the new battery (3 V button cell of type
CR 2025) in the support, positive pole fac-
ing upwards.
3) Push the support back into the remote
control.
Never put batteries in the household
waste. To protect the environment,
always take them to a special waste
disposal, e. g. collection container at
your retailer.
10
6 Operation
Notes:
1. To prevent switching noise, always switch on
the units connected before switching on the
SOUND-4BT/WS. After use, switch off the
SOUND-4BT/WS first.
2. The SOUND-4BT/WS does not save volume
adjustment settings. Therefore reduce the volume
at the respective audio source before switching
on the SOUND-4BT/WS to prevent an undesired
high volume at switch-on.
1) To switch on the SOUND-4BT/WS, use
the POWER switch (5). The blue power
indicator in the upper section of the win-
dow (1) will light up.
2) To switch between the audio sources,
press the respective button on the remote
control:
AUX 1 = source at the input AUX 1
AUX 2 = source at the input AUX 2
OPT = source at the input OPTICAL IN
= Bluetooth mode; the blue Blue-
tooth indicator in the lower sec-
tion of the window (1) will light up
Information on operation with a Bluetooth
source can be found in chapter 6.1.
3) To adjust the volume, use the buttons
VOL+ and VOL- on the remote control.
CAUTION Never adjust a very high vol-
ume. Permanent high volumes
may damage your hearing!
Your ear will get accustomed
to high volumes which do not
seem to be that high after
some time. Therefore, do not
further increase a high volume
after getting used to it.
4) To mute the sound, press the button
MUTE on the remote control. When the
sound is muted, the blue power indicator in
the upper section of the window (1) will
flash. To unmute the sound, press the but-
ton again.
5) To switch to the standby mode, press
the button POWER on the remote control.
In the upper section of the window (1), the
blue power indicator will extinguish and
the red standby indicator will light up. To