Connection And Assembly Of The Digitradio Up1 - TechniSat DIGITRADIO UP 1 Mode D'emploi

3 Connection and assembly of the DIGITRADIO UP1

Caution!
> This device is only intended for installation. Work on the 230 V network may
only be performed by qualified electricians. Life-threatening hazard and fire
hazard from electric voltage of 230 V. Disconnect the mains power supply
prior to assembly / disassembly. No claim can be made under the warranty or
for liability in the event of damage due to incorrect connection.
> 2 x DIN flush-mounted/surface boxes are required for the radio and speaker.
> It is possible to assemble the radio and speaker in a horizontal or vertical
position. When assembling the radio, ensure the correct position of the plug
contacts A for the radio display operating unit.
> The power supply is established via the terminal connections labelled L and N
on the back of the radio unit.
> The antenna must be connected to the terminal connection labelled
ANTENNA.
> Connect the speaker to the terminal connection B. Ensure correct polarity.
If the device is already mounted or assembled, remove the display operating
unit from the radio unit with the help of the frame. If the device is in
the delivery condition, remove the attachment from the radio unit using
your hands. Remove the attachment using your hands only. Under no
circumstances use a screwdriver or similar hard object for removal purposes.
When removing, you must first of all overcome the resistance of the spring
snap-in clips.
> After successful assembly, first of all connect the display operating unit taking
into account the position of the contact strip (A). To do so, carefully push the
display operating unit straight onto the radio unit until it engages.
More detailed installation instructions and illustrations can be found in section
„15 Installation" auf Seite 27.
12
A
-
A
B
+