Operation - Altocraft J1X-KZ18-255 Manuel De L'utilisateur

ASSEMBLY
2. Engage the spindle lock (9 ¿J ) by pressing the pin located between the
KDQGOH DQG WKH ¿[HG JXDUG
CAUTION: Never press the spindle lock pin while the saw is running!
3. Using protective gloves, rotate the blade by hand while pressing the pin until it
engages a slot in the arbor.
4. While holding the spindle lock pin in, and using the supplied wrench, unscrew
the arbor screw UHPRYH WKH RXWVLGH VDZ EODGH ÀDQJH DQG WKH VDZ EODGH
5. Be sure that when mounting the new saw blade, the direction arrows on the
blade correspond with the arrow on the guard.
6. Apply the above procedure in reverse to install the new blade.

OPERATION

CLAMPING WORKPIECE:
WARNING: )RU VDIH DQG DFFXUDWH FXWV ¿[ ZRUNSLHFH ¿UPO\ LQWR FXWWLQJ SRVLWLRQ
with hold down clamp, otherwise the tool and workpiece may be damaged.
1. Mount the hold down clamp on one side of fence. Insert shaft of the hold down
clamp into the mounting holes (L, fig.1) and tighten the hold down clamp retainer
screw (S, fig.2) to fix shaft of hold down clamp.
2. Adjust position of hold down clamp bracket according to workpiece thickness and
shape. Tighten screw to fix the bracket in place.
3. Make sure that when the handle is lowered, bevelled or angled in any position, no
part of the tool contacts the hold down clamp.
START UP
USING YOUR SAW
After unpacking, reading the instructions, attaching the machine to the workbench,
and checking that all attachments are correctly installed, you can use your saw. Be
sure to wear appropriate protective equipment.
WARNING: %HIRUH SOXJJLQJ LQ FRQ¿UP WKDW WULJJHU LV LQ LWV QRUPDO SRVLWLRQ ,I WKH
locking button is not depressed, do not pull trigger with force as this may cause
severe damage to the switch.
REMEMBER:
„
Before use, release the head lock button and let handle off the low position
„
Before turning on, confirm that the saw blade does not touch work piece or
vise at any position.
„
When cutting, press handle down slowly. DO NOT force the handle too much
as this may cause damage to your saw
„
Before starting to cut, confirm that the saw blade has attained full speed.
After cutting is complete wait until the rotation of the blade STOPS
completely before lifting the handle to its top position.
„
For your safety, remove chips, small pieces, etc. from the table top before
operation.
„
For best performance, ALWAYS keep saw blade clean and sharp.
1. Check to ensure everything is correctly attached, screws are fastened, and all
adjusting keys and wrenches are removed.
2. Connect the saw to power.
3. Unlock the saw from its various storage and shipping positions.
4. Squeeze the trigger switch (I, fig.2) the saw will start with the cutting head in
the raised position and the blade fully enclosed in the guard.
21