Safety Instructions For Compound Mitre Saw - Altocraft J1X-KZ18-255 Manuel De L'utilisateur

IMPORTANT SAFETY INSTRUCTIONS
TOOL USE AND CARE
15. Use clamps or other practical way to secure and support the work piece to a
stable platform. Holding the work by hand or against your body is unstable and
may lead to loss of control.
16. Do not force tool.Use the correct tool for your application. The correct tool
will do the job better and safer at the rate for which it is designed.
17. Do not use tool if switch does not turn it on or off. Any tool that cannot be
controlled with the switch is dangerous and must be repaired.
18. Disconnect the plug from the power source before making any adjustments,
changing accessories, or storing the tool. Such preventive safety measures
reduce the risk of starting the tool accidentally.
19. Store idle tools out of reach of children and other untrained persons. Tools
are dangerous in the hands of untrained users.
20. Maintain tools with care. Keep cutting tools sharp and clean. Properly
maintained tools with sharp cutting edges are less likely to bind and are easier to
control. Do not use a damaged tool.Tag damaged tools"Do not use" until
repaired.
21. Check for misalignment or binding of moving parts, breakage of parts,and
any other condition that may affect the tool's operation. If damaged,have
the tool serviced before using. Many accidents are caused by poorly
maintained tools.
22. Use only accessories that are recommended by the manufacturer for your
model. Accessories that may be suitable for one tool may become hazardous
when used on another tool.
SERVICE
23. Tool service must be performed only by qualified repair personnel. Service
or maintenance performed by unqualified personnel could result in a risk of injury.
24. When servicing a tool, ask that only identical replacement parts be used.
Use of unauthorized parts or failure to follow Maintenance instructions may create
a risk of electric shock or injury.

SAFETY INSTRUCTIONS FOR COMPOUND MITRE SAW

„ USE THIS SAW TO CUT WOOD ONLY. The ALROCRAFT mitre saw is
designed for woodcutting only.
„ DAMAGED OR WARPED SAW BLADES should not be used. They are out of
balance and could cause further damage to the saw and possible personal injury.
„ USE ONLY WITH GUARD IN PLACE. The guard protects you the operator from
cutting debris as well as from broken pieces of the blade should it break in use.
„ REPLACE THE TABLE INSERT WHEN WORN. Excessive tear-out increases
the likelihood of injury from flying debris. When setting the saw at a new angle,
check that due to some mis-alignment, the blade does not cut into the table
insert, rear fence, or another part of your saw.
„ ALWAYS USE THE BLADE WRENCH to tighten the saw blade onto the arbor.
„ CONNECT YOUR MITRE SAW TO A DUST COLLECTING DEVICE if possible.
If not, use the dust bag that comes with the tool and empty it regularly.
„
USE A SAW BLADE SUITED TO THE CUTTING JOB AND MATERIAL TO BE
CUT.
„ ALWAYS USE TABLE EXTENSIONS AND CLAMPS to support the material
when sawing long work pieces.
18