Preparing The Printer - Canon PIXMA Pro 9000 Guide De Démarrage Rapide

Preparing the Printer

Be sure to read your setup sheet first for setting up your printer and getting it ready for use.
1
Turn on the printer.
Caution
Be sure to remove the tapes before you turn on the printer.
Note
The tape position is subject to change.
2
Install the Print Head.
Caution
Do not touch internal parts other than the Print Head Lock Lever.
Important
If the Top Cover is opened more than ten minutes, the Print Head Holder moves to the right side. If
this occurs, close the Top Cover, and open it again.
Notes
There might be some transparent or light blue ink on the inside of the bag the print head comes
in, or the inside of the protective cap - this has no effect on print quality. Be careful not to get ink
on yourself when handling these items.
Do not reattach the protective cap once it has been removed.
3
Install the ink tanks.
Important
Ensure that all the ink tanks are installed in the order directed by the label. The printer cannot
be used unless all the ink tanks are installed.
Once you have installed the ink tanks, the POWER lamp will flash green. Wait for about 2
minutes 30 seconds until the POWER lamp displays a steady green light and the printer has
stopped making operating noises before proceeding.
Notes
Be sure to remove the clear film from the ink tank in the exact order as shown in step 3 of your
setup sheet.
Do not squeeze the side of ink tanks as this may cause the ink to leak out and stain your clothes
and hands.
Do not reattach the protective cap once you have removed it.
The ALARM lamp on the printer flashes orange if an ink tank is not installed properly. Open the
Top Cover and make sure that all the ink tanks are installed in the correct order directed on the
label.
4
Load paper.
In the following process, you will be required to perform the Print Head Alignment, and you
will need two sheets of A4 or Letter-sized plain paper loaded in the Auto Sheet Feeder.
Important
When loading paper in the Auto Sheet Feeder, ensure that the FRONT FEED button is not lit.
When it is lit, set the Front Tray to its normal printing position. For details about the position of
the Front Tray, refer to "Returning the Front Tray to Its Normal Printing Position" in the User's
Guide.
Always load paper in portrait orientation. Loading paper in landscape orientation can cause the
paper to be jammed.
2
Preparing the Printer