Geberit RE 1 Mode D'emploi page 20

Maintenance
Spare parts
20
Operating instructions pipe deburrer RE 1
Article no.
90364
90365
90366
691.142.00.1
Have the pipe deburrer serviced at an authorised specialist workshop.
For information about authorised specialist workshops, please contact
your responsible Geberit sales company directly or visit
www.geberit.com.
Cleaning the pipe deburrer
Prerequisites
Pipe deburrer is switched off.
1
Clean the ventilation slots regularly by blowing them out
If the cutting performance of the milling cutter drops, clean
2
it with a wire brush
Replacing the milling cutter
Only use milling cutters with protection spheres.
Immediately replace milling cutters without protection
spheres.
1 Unscrew retaining screw with an Allen key (4 mm)
2 Remove the deburrer head
Designation
Deburrer head
Milling cutter
Protective goggles
Transport case