NOTE
The iQ Connect button is below the RF control knob. If you need to press the
iQ Connect button, remove the RF control knob by grasping it and then pulling it
straight up.
DTG36P875N_DG68-01285A-00_EN+MES+CFR.indb 17
iQ Connect button
iQ Connect LED indicator
To monitor the cooktop remotely
1.
Make sure the iQ Connect LED indicator turns on. If the iQ Connect LED
indicator does not turn on, press the iQ Connect button. The cooktop can now be
monitored remotely with a connected remote device.
Select the cooktop icon on the SmartThings app to open the cooktop monitor
2.
app.
iQ Connect on/off
If you set the iQ Connect to Off, mobile devices cannot connect to the cooktop. To
turn iQ Connect on, follow these steps:
1.
Pull the RF control knob straight up to remove it.
2.
Press the iQ Connect button.
NOTE
The iQ Connect LED indicator is on when iQ Connect is enable. The iQ Connect LED
indicator is off when iQ Connect is not enabled.
3.
Put in the RF control knob.
NOTE
•
The cooktop continues operating even if the Wi-Fi connection is lost.
•
SmartThings Application will not work properly if the Wi-Fi Connection is
unstable.
•
See the SmartThings app manual for detailed information.
•
For further instructions, refer to the SmartThings app web manual at
www.Dacor.com
English 17
2020-05-27
10:57:05