Remote Control Unit - Teac MC-DX30 Manuel Du Propriétaire

J SKIP (.//) / TUNING
In CD mode, momentarily press this button to skip tracks.
Hold down this button to search for a part of a track.
In TUNER mode, momentarily press this button to tune in
stations.
In Standby mode, these buttons are used to set or adjust the
clock and the timer.
K CD door
L Display
M
STOP (H)
Use this button to stop playback of CD/MP3.
N
REPEAT/PTY
In CD mode, use this button for repeat playback.
In FM TUNER mode, use this button to start PTY search.
O TIMER
Use this button together with the SKIP buttons to set the
timer.
P
BASS
Use these buttons to adjust the bass sound up or down.
Q
TREBLE
Use these buttons to adjust the treble sounds up and down.
R
MP3 FOLDER/PRESET
In TUNER mode, use these buttons to select preset stations.
During playback of a MP3 disc, use these buttons to select a
folder in the disc.
S SLEEP
Use this button to set sleep timer.
T SHUFFLE/RDS
Use this button for shuffle playback.
In FM TUNER mode, use this button to select an RDS mode.
U MUTING
Use this button to mute the sound.
Note:
To simplify explanations, instructions in this manual refer to
the names of the buttons and controls on the front panel
only. Associated controls on the remote control will also
operate similarly.

Remote Control Unit

The provided Remote Control Unit allows the unit to be operated
from a distance.
When operating the remote control unit, point it towards the
remote sensor on the front panel of the unit.
< Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there
are any obstacles between the unit and the remote control.
< If the remote control unit is operated near other products
which generate infrared rays, or if other remote control
devices using infrared rays are used near the unit, it may
operate incorrectly. Conversely, the other products may also
operate incorrectly.
Battery Installation
1
2
3
1. Remove the battery compartment cover.
2. Put in the lithium battery (CR2032, 3V).
3. Close the cover.
Battery Replacement
If the distance required between the remote control unit and
main unit decreases, the battery is exhausted. In this case,
replace the battery with a new one.
Precautions concerning batteries
Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
7