Publicité
Les langues disponibles
Les langues disponibles
2. Tap the sensor with your hand. Tap it at
the strength where the sensor should
trigger an alarm.
The calibration mode LED flashes:
Once for a small vibration
Twice for a vibration that triggers an
alarm
Three times for a strong vibration
3. Adjust the potentiometer until the LED
flashes twice at every vibration in the
desired sensitivity range.
4. Remove jumper A if the sensor does not
register all vibrations in the desired sen-
sitivity range.
5. Remove jumper C when the sensor has
been set to the desired sensitivity. This
puts the detector into normal operating
mode.
Information on device disposal
The EU Directive 2012/19/EU
regulates the proper return, treat-
ment and recycling of used elec-
tronic devices. This symbol means
that in the interest of en-vironmental protec-
tion the device must be disposed of sepa-
rately from household or industrial waste at
the end of its service life in accordance with
applicable local legal guidelines. Disposing
23
Publicité
