Publicité
Les langues disponibles
Les langues disponibles
- Next to the floor
- Near large metal structures
- Less than 1 metre away from power or
gas lines
- Near electronic or wireless devices
- On moveable elements
- Upside down
When large areas are monitored, the dis-
tance between two detectors cannot be
more than 10 metres.
Installation
1. Open the housing by loosening the
screw on the front of the sensor and re-
moving the cover.
2. Remove the PCB from the housing by
pulling it carefully from the plastic
clamps.
3. Hold the housing base at the desired
position on the wall and mark the screw
positions for fixing.
4. Fix the rear housing side in the marked
position with two screws. The rear of the
housing must lie flat on the surface so
that the wall removal contact is closed.
5. Insert the enclosed 3V CR2 lithium
battery correctly.
19
Publicité
