Ipod Operation; Accessing Ipod Mode - Jensen VM8113R Guide D'instructions

iPod OPERATION

Accessing iPod Mode

This unit is Made for iPod. You can control your iPod via the head units front
panel buttons and access Playlist, Artist, Album, Songs, etc. Models
supported but not limited to:
• iPod Classic
• iPod Touch
• iPod Touch 2G
• iPod Nano 3G
• iPod Nano 4G
NOTE: Be sure your iPod has the latest Apple firmware installed to
avoid connectivity issues.
The unit will automatically switch to iPod mode when an iPod is plugged
into the USB connector. To return to the iPod screen from any other source,
press the SRC button on the front panel (6) or remote control (14) and
select SOURCE >> iPod. After switching to iPod source, the iPod menu
appears on the screen.
NOTE: For basic iPod connectivity, you can use the white 30-pin to
USB iPod cable that came with your Apple device. For iPod video or
photo playback, you must purchase the jLink-USB cable.
The following remote control buttons are used to access the iPod menus:
Menu
Music AUDIO
Videos TITLE
Photos MENU > Arrow Down > ENTER
iPod File Playback
The iPod menu is automatically accessed when an iPod is connected to the
unit or the source is changed to iPod while the iPod is connected.
• Use the navigation arrows on the remote control (5) or the 5 DN/6 UP
buttons on the control panel to navigate the iPod menu and choose
"MUSIC", "VIDEO" or "PHOTO".
• Press the ENTER ( ) button on the front panel (16) or remote control
(6) to select the highlighted menu option.
• Press the BAND button on the front panel (3) or remote control (25) to
return to the previous menu.
Remote Control
• Press the >/|| button on the front panel (8) or remote control (18) to play
or pause the selected track.
• Press the >>| button on the front panel (17) or remote control (12) to
play the next file.
• Press the |<< button on the front panel (17) or remote control (12) to
return to the beginning of the current file.
• To return to the iPod menu while viewing a video/photo, press the
BAND button.
Fast Forward/Fast Reverse
Press and hold the |<< or >>| buttons on the control panel (17) or remote
control (12) for 1 second and continue to hold for fast forward or fast
reverse. Release to resume normal playback.
NOTE: To transmit the video from your iPod to the VM8113R screen, you
must set the following options through the iPod video settings menu:
TV Out = On, TV Signal = NTSC, and Widescreen = On.
NOTE: After disconnecting your iPod, the VM8113R will always return to
the last mode accessed when the iPod is plugged back into the unit.
14
VM8113R