TechniSat AUDIOMASTER MR1 Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 44
In the event of a thunderstorm, disconnect the device from the mains. Overvoltage can damage the device.
In the event of an obvious fault with the device, emanation of odour or smoke, substantial malfunctions,
damage to the housing or fluid ingress, immediately switch off the device and contact the Service
department.
The power supply unit may only be connected to a mains voltage of 100V-240V~, 50/60 Hz.
Never try to operate the device with another voltage.
The power supply unit must not be connected until the installation has been completed according to
regulations.
Do not operate the device if the power supply unit is defective or if the device is damaged in any other way.
When removing the power supply unit from the power outlet, pull on the plug, not the cable.
Do not put the device into operation in the vicinity of baths, swimming pools or splashing water.
Never try to repair a faulty device yourself. Always contact one of our customer service locations.
Foreign bodies, e.g. nails, coins, etc., must not be allowed to fall inside the device. Do not touch the
connection contacts with metal objects or fingers. This could lead to short-circuits.
Do not place any open flames such as burning candles on the device.
Never allow children to use the device unsupervised.
Even when switched off and on standby, the device is still connected to the mains power supply. If you
do not intend to use the device for a prolonged period, remove the mains plug from the power outlet.
Only pull on the plug, not on the cable.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
11

Publicité

Table des Matières
loading

Produits Connexes pour TechniSat AUDIOMASTER MR1

Table des Matières