Makita LS1216 Manuel D'instruction page 11

Aligning the laser line
A B
009494
Laser line can be shifted to either the left or right side of
the blade according to the applications of cutting. Refer
to explanation titled "Laser beam action" regarding its
shifting method.
NOTE:
Use wood facing against the guide fence when
•
aligning the cutting line with the laser line at the
side of guide fence in compound cutting (bevel
angle 45 degrees and miter angle right 45
degrees).
A) When you obtain the correct size on the left side of
workpiece
Shift the laser line to the left of the blade.
•
B) When you obtain the correct size on the right side of
workpiece
Shift the laser line to the right of the blade.
•
Align the cutting line on your workpiece with the laser
line.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off and
•
unplugged before working on the tool. Failure to
switch off and unplug the tool may result in serious
personal injury.
Socket wrench storage
1
009495
The socket wrench is stored as shown in the figure.
When the socket wrench is needed it can be pulled out
of the wrench holder.
1. Wrench holder
2. Socket wrench
2
After using the socket wrench it can be stored by
returning it to the wrench holder.
Installing or removing saw blade
WARNING:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the
blade. Accidental start up of the tool may result in
serious personal injury.
Use only the Makita socket wrench provided to
•
install or remove the blade.Failure to use the
wrench may result in overtightening or insufficient
tightening of the hex bolt and serious personal
injury.
Lock the handle in the raised position by pushing in the
stopper pin.
009483
To remove the blade, use the socket wrench to loosen
the hex bolt holding the center cover by turning it
counterclockwise. Raise the blade guard and center
cover.
1
2
009497
Press the shaft lock to lock the spindle and use the
socket wrench to loosen the hex bolt clockwise. Then
remove the hex bolt, outer flange and blade.
11
1. Stopper pin
1
1. Center cover
2. Socket wrench
3
3. Hex bolt
4. Blade guard
4