Environmental Instructions; Application Examples - Würth RL1-18 Traduction Des Instructions De Service D'origine

Accuracy test
Perform the accuracy test before using the device
for the first time, then at regular intervals. In case
of deviations, send the device to Würth Master
Service.
Horizontal accuracy (Fig. II)
Set up the device between two walls, maintain
■
a distance of about 0.3 m from one and 10 m
from the other wall.
Switch the rotation laser on and wait until it
■
rotates.
Mark point a1 on the wall which is about 0.3 m
■
away.
Mark point b1 on the wall which is 10 m away.
■
Turn the device through 180°.
■
Align the horizontal beam so that it is identical
■
in height with point a1.
Now measure the difference between the hori-
■
zontal beam and point b1.
Note
The specified accuracy is the maximum
difference allowed.

Application examples

Levelling, transferring benchmarks/
datums
Level the laser to the required height.
Mark the points on the laser line or project the
height difference between laser beam and the
required height using a metre rule.
Maintenance / care
Do not use aggressive cleaning agents or solvents.
Clean the laser windows with a soft cloth.
In the unlikely event of a failure or defect, have the
appliance examined and repaired by an authorised
customer service point for Würth power tools.
In all your queries and spare part orders, always
quote the 10-digit product number (see type plate)
of your device.

Environmental instructions

Do not throw the device away with
normal domestic waste. Dispose of
the device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regula-
tions. In case of doubt, contact your
waste disposal facility. Recycle all packaging
material in an environmentally friendly manner.
Battery packs/batteries:
Do not dispose of batteries with domestic waste,
do not expose to fire or water. Collect and recy-
cle batteries or dispose of with due care for the
environment.
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of purchase
through invoice or delivery note). Damage that has
occurred will be corrected either by replacement or
by repair. Damage caused by improper handling is
not covered by the warranty. Claims under warranty
can only be accepted if the device is returned fully
assembled to a Würth agency, your Würth sales
representative or an authorised Würth customer ser-
vice workshop. Subject to technical changes without
prior notice.
We accept no liability for printing errors.
Spare parts
If in spite of careful manufacturing and test proce-
dures, the device becomes faulty, a repair by Würth
masterService should be arranged.
With any enquiries or spare parts orders, always
quote the article number as given on the device type
plate.
The latest spare parts list for the device is available
online at http://www.wuerth.com/partsmanager.
Alternatively, contact your local Würth agency for a
hardcopy.
13