Battery Charger; Intended Use; Device Elements - Würth RL1-18 Traduction Des Instructions De Service D'origine

Battery charger

Read all safety precautions and
instructions. Failure to observe safety
precautions and instructions may lead
to electric shock, fire and/or severe
injury.
Protect the charger from rain
or moisture.
If water enters the charger, there is an
increased risk of electric shock.
Do not charge other batteries with
■
the charger. The charger is designed solely
for use with the batteries supplied with the
laser. If batteries of other manufacturers are
charged, there is a risk of fire and explosion.
Always check charger, lead and plug
■
before use. Do not use the charger
if it is damaged. Do not open the
charger yourself; if repair is neces-
sary it must be repaired by qualified
specialist personnel using original
spare parts only. Damaged chargers,
leads and plugs increase the risk of an electric
shock.

Intended Use

The device is designed for establishing and checking
exactly horizontal lines and inclined lines. Any other
use is considered an improper use.
The user is solely responsible for damage
resulting from improper use.
Keep the charger clean. Dirt could cause
■
an electric shock.
Do not operate the charger on easily
■
flammable surfaces (e.g. paper,
textiles etc.) or in a flammable
environment. Risk of burning due to high
temperatures generated by the charger during
charging.
If used incorrectly, battery fluid may
■
escape. Avoid contact with it. Rinse
with water after accidental contact. If
the fluid comes into contact with your
eyes, seek medical attention. Escaping
battery fluid can cause skin irritation or burns.
Use only genuine Würth accessories
■
and spare parts. When using non-rec-
ommended accessories, you may receive
incorrect measuring values.

Device elements

Overview [fig. I]
1 Mode indicator
2 Button for inclining and moving the scanning
beam in an anticlockwise direction
3 Button for manual, automatic or ADS mode
4 Battery power indicator
5 Keypad
6 Carrying handle
7 Battery compartment
8 Charging socket and charger LED
9 Mains adapter
10 Button for rotation speed and scanning mode
11 Button for inclining and moving the scanning
beam in a clockwise direction
12 ALARM display
13 Device on/off button
11