Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Mounting the parallel stop
•
If required, attach the parallel stop item 15. When not in use, fix it in the holder under the
clamp item 16.
Free-hand cutting
Before use, check the saw and the saw blade for damage.
•
Loosen wing nut item 18 and pull the saw out of the guide item 10 (see fig. 13).
•
During cutting, always hold the saw with both hands (see fig. 14) (Two-hand-operation).
•
Put the spacer item 20 along the material.
•
Start the saw. Slowly feed the saw blade item 19 along material.
•
After making the first cut, increase the pressure. Apply uniform feed through the material.
•
After cutting, release the valve trigger.
•
After working, re-attach the saw to the clamp.
Fig. 11
Fig. 12
59
Publicité
Table des Matières
