Levelling Unit; Tensioned Crosspiece; Stand - Alpego PUMA PF Série Manuel D'utilisation Et Entretien

OWNER'S MANUAL OF THE MULCH CULTIVATOR PF-PD

5.5. LEVELLING UNIT

The disc system acts as a levelling unit. The discs, which have a diameter of 460 mm, they mix, crumble and level
out the earth. The working depth of the disc unit is set using a crank. The outer elements can be set separately to the
next working depth to enable clean transit.

5.6. TENSIONED CROSSPIECE

The tensioned crosspiece (second and third category) is used to couple the machine to the tractor. Secure the
tensioned crosspiece using clip pins to prevent unintentional releasing of the attached machine

5.7. STAND

The stand is used in trailed Puma rudder.
•
Stand raised for use or transport.
•
Stand lowered with machine uncoupled.
A bolt with star grip locks the stand in place when raised or lowered.
Raising / lowering the stand:
1. Pull out the pin
2. Raise/slowly lower the stand.
3. Put in the pin and lock it.
4. Check that the stand is locked in place in the respective end position
Copyright ©2009 della Alpego spa® - All rights are reserved. Reprinting or unauthorized use of this manual is strictly forbidden without written permission by Alpego spa
II cat
III cat
Figure 5-3
Figure 5-3
Old Cod.Q00A00142
New Cod. MANT2010/00493 R.1
STRUCTURE AND FUNCTIONALITY
- 18