Danger Area And Danger Points; Hydraulics Diagram (For Pd Puma) - Alpego PUMA PF Série Manuel D'utilisation Et Entretien

OWNER'S MANUAL OF THE MULCH CULTIVATOR PF-PD

2.4. DANGER AREA AND DANGER POINTS

The danger area is the area around the machine in which people can be caught:
•
By work movements made by the machine and its tools
•
By materials or foreign objects ejected by the machine
•
By tools rising or falling unintentionally
By unintentional rolling of the tractor and the machine
Here, the special safety regulations of the appropriate section shall be valid.
No-one may stand in the machine danger area:
•
as long as the tractor engine is running
•
as long as the tractor and machine are not protected against
unintentional start-up and running.
The operating person may only move the machine or switch or drive the tools from the transport position to the
working position or viceversa when there is no-one in the machine danger area.
Within the machine danger area, there are danger points with permanent or unexpected risks. Warning pictograms
indicate these danger points and warn against residual dangers, which cannot be eliminated for construction
reasons.

2.5. HYDRAULICS DIAGRAM (FOR PD PUMA)

LIFTING (Rear Axle)
1. Hydraulic ram
2. Hydraulic block
3. Non-return pilot valve
4. Tractor fast linkages
Figure 2-3
Copyright ©2009 della Alpego spa® - All rights are reserved. Reprinting or unauthorized use of this manual is strictly forbidden without written permission by Alpego spa
FOLDING CIRCUIT (Folding arms)
1. Tractor fast linkages
2. Hydraulic ram
3. Speed Limiter
4. Check valve
5. Hydraulic cylinder for safety device
Old Cod.Q00A00142
New Cod. MANT2010/00493 R.1
TECHNICAL SPECIFICATION
- 6