SpeedEPart Agri-Fab 45-01773 Notice D'utilisation page 6

23. Slide the axle through the axle clamps. See figure 12.
24. Assemble a cotter pin to the inner hole at one end of the
axle. Place a large flat washer, a wheel and then another
large flat washer onto the axle. Secure the wheel with
a cotter pin assembled to the outer hole at the end of
the axle. Repeat step for other wheel. See figure 12.
25. Center the wheels and axle side to side. Tighten the
four nuts on the axle clamps.
AXLE
LARGE
FLAT
FIGURE 12
26. Turn cart right side up, so that it rests on its wheels.
27. Place front panel in guides to complete assembly.
28. Your cart is now ready to use.
COTTER
PIN
COTTER
PIN
WASHER
LARGE
FLAT
WHEEL
WASHER
ENGLISH
MAINTENANCE
1. Grease or oil wheel bearings occasionally. Use
automotive wheel bearing type grease or 20 weight
oil.
2. Periodically retighten all screws, especially after heavy
use. Do not exceed load capacity rating of 400 lbs.
. Clean cart thoroughly after each use.
4. Store indoors during severe weather.
5. Apply light coat of varnish to all wood surfaces
annually.
6. Use glossy black enamel spray paint to touch up
scratched or worn painted metal surfaces.
RECOMMENDED TIRE PRESSURE 25-30 PSI
DO NOT EXCEED MAXIMUM PRESSURE PRINTED
ON TIRE
6