Instructions Of Use - Jata calor AT10 Instructions D'usage

Masquer les pouces

Table Des Matières

Table des Matières

• The fixed installation of this appliance on the wall of a bathroom

always must be done at a distance where no person in the shower

or in the bath may touch it or switch it on.

• Do not rest the cable on hot parts of the appliance.

• The heater can produce smell during the heating, which is normal

in this kind of appliances.

• If the cable were to deteriorate it must be changed by an Authorised

Service Centre.

FEET ASSEMBLING

• Place the supports with the wheels (5) in the bottom part of the

appliance. Make the 2 holes of the support match up the 2 holes

of the metallic sheet and screw them. (Fig A)

WALL ASSEMBLING

• The wall assembling support is mounted from the factory. In order

to proceed to the wall mounting, you have to follow these steps:

1.Take the wall mounting support away from the appliance body by

pressing the two tongues of the lower part and taking them away

of their location.

2.Then slide the support to the lower part of the appliance and take

it away.

• Before installing definitively on the wall, you have to take into

account that the support has to respect, once installed, the following

distances:

From the floor: 250 mm.

• All objects (table, shelve etc.) must be 30 cm. over the appliance.

• The distances of fig. B have to be respected. These distances will

vary in function of the model you have chosen. Find below the

distances:

MODEL

Distance A

Distance B

• To fix the appliance to the wall. (Fig B)

- Place the support (6) against the wall and mark the holes.

- Perforate the wall on the marked holes and insert the raw plugs.

- Fix the support to the wall with the screws provided with the

appliance.

- Place the radiator inserting the upper flanges of the support in the

corresponding windows and press down to get it correctly fixed.

- Next, in the lower part and using both hands, make the tongues

of the support match up the corresponding holes and press the

appliance against the support.