English; Important; Toasting Bread - Philips Essence HD2580 Mode D'emploi

ENGLISH

6

Important

Read these instructions for use carefully before using the appliance and save them for future
reference.
Check if the voltage indicated on the bottom of the appliance corresponds to the voltage in
your home before you connect the appliance.
Connect the appliance to an earthed wall socket.
Avoid touching the metal parts of the toaster, as they get very hot during toasting. Only touch
the controls and lift the appliance by its plastic body.
Do not immerse the appliance or mains cord in water or other liquids.
Only allow children to operate the toaster under close supervision.
Never let the toaster operate unattended.
Unplug the appliance before cleaning. Remove the plug by gripping the plug body and pulling it
from the socket. Never yank or twist the cord.
Do not use the toaster under or near curtains or other flammable materials. Do not operate it
under wall cabinets. Please note that bread may burn.
If a slice of bread gets stuck inside the toaster, unplug the appliance and allow it to cool down
before trying to remove the bread. Do not use a knife or a sharp tool, as these may cause
damage to the heating elements.
This appliance is only intended for household use. It is not intended for commercial or industrial
use.
If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by
Philips or similarly qualified persons in order to avoid a hazard.
The appliance is only meant for toasting bread. Do not put any other ingredients in the appliance, as
this may lead to a hazardous situation.
Oversized foods, metal foil packages or utensils must not be inserted into the toaster, as this may
cause a fire or an electrical shock.
Immediately unplug the toaster if fire is observed.
Before using the toaster for the first time
- Remove any stickers and wipe the body and top of the toaster with a damp cloth.
- Let the toaster first complete one toasting cycle without inserting any bread to burn off any
dust that may have accumulated on the heating elements during storing.

Toasting bread

1 Put the appliance in a safe place, away from fire hazards such as curtains, and insert the plug
into the wall socket.
After you have inserted the plug, the LEDs will blink quickly from left to right and back until the LED
of the third browning level starts to burn continuously to indicate that the toaster has reached its
initial setting. If the toaster has not been used for 10 minutes, it will go into sleep mode, which
means that all LEDs will go out.
You can re-activate the toaster by pressing any button.The LED of the last browning level selected
will go on again.
You can adjust the length of the cord by winding part of it round the brackets in the base of
the appliance (fig. 1).
2 Put one or two slices of bread in the toaster (fig. 2).
The type of bread and the state of the bread have no effect on the end result. Frozen, defrosted,
fresh or old bread - the toaster's advanced sensor system always guarantees the same result.
Note:When you want to toast only one slice of bread, always put it in the front slot of the toaster
because of the location of the sensor.