Wolf STEAMER MODULE Guide D'utilisation Et D'entretien page 8

CA RE R EC O M M EN D ATIONS
Care Recommendations
C L E A NI N G
Stainless steel Use a nonabrasive stainless steel cleaner and apply with a soft lint-free cloth. To bring out the natural luster,
lightly wipe surface with a water-dampened microfiber cloth followed by a dry polishing chamois. Always
follow the grain of stainless steel.
Control panel Use a spray degreaser to remove fingerprints and food soil. Spray on a cloth before wiping panel.
IMPORTANT NOTE: Do not spray cleaners directly on the control panel.
Glass lid The glass lid is dishwasher safe, or wash by hand with warm water and mild detergent. Rinse and dry
thoroughly.
Insert pans Solid and perforated insert pans are dishwasher safe, or wash by hand with warm water and mild
detergent. Rinse and dry.
Drain strainer The strainer should remain in the drain outlet during normal use and cleaning. Lift the strainer out and rinse
after each use to remove food particles.
Steamer basin Drain water from steamer basin. Refer to page 7. Pour warm water with mild detergent into the empty basin.
Scrub with a nylon brush. Rinse well, drain and dry thoroughly. For hard water calcium deposits, clean with
white vinegar and water or a cleaner designed to remove minerals. Let mixture stand in the steamer basin,
then scrub with a nylon brush. Rinse well. For soft water salt deposits, wipe out with a wet cloth. Rinse well.
|
8 English
T RO U BL E S HO O T ING
Troubleshooting
OP E RATIO N
Steamer module does not operate.
• Verify power is on.
• Verify electrical power to module and home circuit
breaker is on.
• Module is in lock mode. Touch and hold for three
seconds to unlock control panel.
• Module will automatically turn off after 12 hours of
continuous use when set at 80°C or higher.
'LO' appears on the control panel display.
• Water level is too low. Power to the heating element is
automatically turned off. Refer to water level, page 6.
Module temperature issue.
• Contact your authorized Wolf dealer for recommenda-
tions.
SE RV IC E
• Maintain the quality built into your product by contacting
Wolf factory certified service.
• When contacting service, you will need the model and
serial number of your product. Both numbers are listed
on the product rating plate. Refer to page 4 for rating
plate location.
• For warranty purposes, you will also need the date of
installation and name of your authorized Wolf dealer. This
information should be recorded on page 2 of this guide.