Télécharger Imprimer la page

GE JX2027 Mode D'emploi page 4

Publicité

6
CHECK LEVELING
Check the leveling by placing a
level at the front and sides of the
microwave. It may be necessary to
add wood shims under the bottom
duct to level the microwave front to
back or side to side.
7
INSTALL THE TOP BRACKET
Ensure that
Top Bracket
is Level
A
Place the top bracket flange on top of the upper duct with the
opening of the top bracket lined up with the opening on the
upper duct.
B
Align the center line marking on the top bracket with the
center line drawn on the top front face of the cabinet at the
center of the cutout.
C
Ensure the top bracket is level and mark screw hole locations
on the cabinet face.
Drill pilot holes through the side holes in the top bracket.
D
Secure the top bracket to the cabinet using four round-head
screws (see illustration in step 8).
❒ ❒
8
INSTALL THE BOTTOM BRACKET AND
SECURE THE TOP BRACKET
Round-Head
Screws
A
Drill pilot holes through the three holes on the front flange of
the bottom duct assembly.
B
Hold the bottom bracket against the front flange of the bottom
duct assembly, lining up the three holes in the bottom bracket
with the three holes in the bottom duct. Screw in three round-
head screws. Drill pilot holes through the four holes in the
tabs on the sides of the bottom bracket. Screw in four round-
head screws.
Installation Instructions
Align Center
Lines on
Cabinet and
Top Bracket
Mark Screw
Hole Locations
(also on left
side of
bracket)
Cutout
Opening
Positioning
Flange
9
INSTALL THE TRIM FRAME
Place the trim frame over the microwave oven with the
A
curved edge at the top.
B
Press the trim frame into the opening until all sides snap
into place.
C
Open the microwave oven door. Secure the trim frame using
four flat-head screws (two on the inside top and two on the
inside bottom).
Flat-Head
Screws
10
REPLACE ANY LOOSE ITEMS
A
Your trim kit is now fully installed. Replace the turntable and
turntable support that were removed from the inside
of the microwave oven.
B
Keep these installation instructions and extra screws for
future reference and need. Do not place them in the
microwave oven.
C
Replace house fuse or close circuit breaker.
MFL38268402
49-40552-1
10-07 JR
Flat-Head Screws
Printed in China

Publicité

loading

Ce manuel est également adapté pour:

Jx2030