Denon DJ VL12 PRIME Guide D'utilisation page 3

Features
Top Panel
4
1
2
3
1. Power Switch & Strobe Light: Turn this dial at the top of the strobe light to power VL12
Prime on or off.
The strobe light illuminates the edge of the platter, which indicates whether or not the
phase of the platter's rotation is constant. As the platter rotates, look at the vertical lines
on its edge under the light's strobing. If the phase is constant, the lines will appear to be
still. If the rotation is out of phase, the lines will appear to move or "drift".
2. Start/Stop: Press this button to start and stop the platter's motor. If the platter appears
not to be functioning, make sure it is properly secured (see
3. 33 & 45 RPM Buttons: Press one of these buttons to set the rotation speed (RPM) of the
platter. The lit button indicates the current selection.
4. 45 RPM Adapter Holder: Use this spindle to hold the 45 RPM adapter when not using it.
5. Platter: Place the platter onto the motor before using it. See
information on securing the platter.
6. Target Light: The target light (included) illuminates the grooves on your record so you can
visually track the stylus in dark environments. To turn it on, secure it to this connector. To
turn it off, remove it from the connector.
Note: To prevent damage, we recommend removing the target light before packing or
transporting VL12 Prime.
5
6
16
13
10
9
11
12
Setup Platter).
Setup Platter
17
15
14
7
8
for detailed
3