Audio-Technica AT-LP60-BT Manuel D'installation page 9

Tips For Better Performance
• When opening or closing the turntable cover, handle it gently,
moving it either at the center or equally from both sides.
• Do not touch the stylus tip with your fingers; avoid bumping
the stylus on the turntable mat or a record's edge.
• Clean the stylus tip frequently, using a soft brush with a
back-to-front motion only.
• If you use a stylus cleaning fluid, use it very sparingly.
• Wipe the dust cover and turntable housing gently with a soft
cloth. Use only a small amount of mild detergent solution to
clean the turntable and dust cover.
• Never apply harsh chemicals or solvents to any part of the
turntable system.
• Prior to moving the turntable, always unplug it from the AC
outlet and fasten the tone arm on the tone arm rest with the
vinyl twist-tie.
Specifications
Communication system
Output
Maximum communication range
Compatible Bluetooth profile
Support codec
Type
Platter
Motor
Speeds
Wow and flutter
Signal-to-noise ratio
Cartridge
Output level
Pre-amplifier "PHONO"
Pre-amplifier "LINE"
Phono pre-amp gain
Power
Dimensions
Net weight
Accessories
Replacement stylus
• The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Audio-Technica Corporation is under license.
All other trademarks are property of their respective owners.
•
For product improvement, the product is subject to modification without notice.
Bluetooth Ver. 3.0
Bluetooth
Specification Power Class 2
Line of sight - approx. 10m
A2DP
SBC
Belt drive turntable, fully automatic
Aluminum
DC servo-controlled
33 / RPM, 45 RPM
1
3
Less than 0.25% (WTD) @ 3 kHz (JIS)
>50 dB (DIN-B)
Integral Dual Moving Magnet stereo cartridge with diamond stylus
™
2.5 mV nominal at 1 kHz, 5 cm/sec
150 mV nominal at 1 kHz, 5 cm/sec
36 dB nominal, RIAA equalized
120V AC, 60 Hz, 3W (U.S. and Canada)
360.0mm (14.17") W x 97.5 mm (3.84") H x 356.0mm (14.2") D
2.98 kg (6.6lbs.)
3.5 mm (1/8") mini-plug (male) to dual RCA (male) stereo output cable, 45 RPM adapter, removable hinged
dust cover
ATN3600L
English
Specifications
9