To Start Engine; Operating Instructions - Garland BG 65 Manuel D'utilisation

TO START ENGINE

Before starting engine:
Make sure check the engine oil and fuel tank before
starting the engine.
WARNING!
DAMAGE TO YOUR EYES, HANDS, AND EARS COULD
RESULT FROM USING THIS MACHINE WITHOUT
PROPER PROTECTIVE GEAR. ALWAYS WEAR SAFETY
GLASSES, HEARING PROTECTION, AND LEATHER
GLOVES WHEN OPERATING THIS MACHINE.
LOOSE HAIR AND CLOTHING COULD GET CAUGHT IN
THE MACHINERY AND CAUSE SERIOUS PERSONAL
INJURY. KEEP LOOSE CLOTHING AND LONG HAIR
AWAY FROM MOVING MACHINERY.
Cold engine start:
A: Move On/Off switch to "On" position.
B. Pull the starter rope until the engine start up.
STARTER ROPE
C. Move the air lever to the "CLOSE" position.
AIR LEVER
D. Move the throttle to the high position.
THROTTLE
E. Pull the starter grip until the engine starts up and
go past the air lever slowly to the OPEN position
(normal working position). Put the throttle lever
in the down position and let the engine warm for
1 minute before starting to work.
Warm engine start:
Follow the A & B steps on the Cold engine start. Move
the throttle to middle position and pull the starter grip
until it starts.
To stop engine:
Move the throttle lever to the down position and the
engine switch OFF. If you put the Shredder away,
move the lever to the passage of gasoline in the OFF
position.

OPERATING INSTRUCTIONS

Make sure the plastic cover over the hopper is closed
when the shredder is running. Splinter can jump and
be dangerous.
- To move the machine pick it fi rmly grips of both
hands,turn the wheel with your foot, lift the
machine, pay attention to the central bar of the
machine and walk slowly.
- Before start operating, check the wind direction to
not work face to the gases.
- Keep all warnings and refl ectors in place and in
good working condition.
- Switch off the machine before refuel.
English | 26
English | 26
HIGH DOWN