Normal Playback; Cd Operation - iSymphony V1BLUE Manuel D'utilisation

CD OPERATION

Normal Playback

Press the FUNCTION / button to select "CD" function.
Press the OPEN/CLOSE button on front panel to open the CD door.
Load a disc into the player with the printed label facing out.
Press the OPEN/CLOSE button to close the CD door.
The display will show flashing "READ" as the player
reads the table of contents on the disc.
After reading the disc, the display will show the total
tracks and playing time.
NOTE: The reading time may be longer if you are using CD-R or CD-RW discs. This is normal and not
an indication of any problem with your unit.
18
Press the PLAY/PAUSE button to begin playback.
Playback will continue until all tracks on the disc have been played. Then the player stops and the
display shows the total tracks number and playing time on the disc.
To stop playback at any time, press the
Pause Control
To pause temporarily during CD playback
Press the PLAY/PAUSE button.
The sound stops and the elapsed time flashes in the display,
but the disc continues spinning.
Press the PLAY/PAUSE button once more to cancel Pause
mode and resume playback at the same point. The elapsed time
stops flashing.
Skip Track and High Speed Music Search
During playback, repeatedly press the SKIP/TUNING
numbered tracks. Playback will begin on the selected track.
During playback, depress and hold the SKIP/TUNING
high speed to locate a specific musical passage.
Release the SKIP/TUNING
or
Normal speed playback will resume at that point.
STOP/BAND button.
or buttons to skip to higher or lower
or buttons to search within a track at
buttons when you hear the desired passage.
19