DK2 MMT5X7G Guide D'assemblage page 3

Step 2
Place springs and tongue tubes as shown, the hub end of the spring faces towards
the front of the trailer, insert the two M12 x 115 mm bolts from inside out through the
tongue tube then the spring hub on the front. Use the M12 x 90 mm bolts at the back,
again inserted from the inside out ward. Install the M12 lock nuts fi nger tight on the
outside of the frame.
Tighten until spring is secure. Do not over-tighten as it will collapse spring channel.
En.a3
v.171214