Cleaning And Care - Klarstein 10029462 Mode D'emploi

• The oven should be cleaned after every use. When cleaning the oven the lighting should be switched on
to enable you to see the surfaces better. The oven chamber should only be washed with warm water and
a small amount of washing-up liquid. After cleaning the oven chamber wipe it dry. Never clean the oven
surfaces by steam cleaning.
• Any stains that may appear on the bottom of the oven will have originated from food splashes or spilt food,
these splashes occur during the cooking process. These could possibly be a result of the food being cooked
at an excessively high temperature or being placed in cookware that is too small.
• You should select a cooking temperature and function that is appropriate for the food that you are cooking.
You should also ensure that the food is placed in an adequately sized dish and that you use the drip tray
where appropriate.
• Outer parts of the oven should only be cleaned with warm soapy water, using either a sponge or soft cloth.
No abrasive cleaners should be used. If you use any form of oven cleaner on your appliance, then you must
check with the manufacturer of the cleaner that it is suitable for use on your appliance. Any damage that is
caused to the appliance by a cleaning product will not be fixed free of charge, even if the appliance is within
the guarantee period.
Replacement of the oven light bulb
In order to avoid the possibility of an electric shock ensure that the appliance is switched off before replacing the bulb.
• Remove all oven shelves, the drip tray and the side rack that is on the
same side as the oven light. Using a screwdriver, remove the lamp cover.
• Remove the light bulb and replace it with a 230V, 25W/ 300°C,
cap G9 bulb. Do not use any other type of bulb.
• Place the lamp cover back into position. There is a curve on lamp
cover one side of the cover; this should be on the right hand side as
the cover goes back into place.
• Plug the bulb in, making sure it its properly inserted into the cera-
mic socket. Do not touch the light bulb directly with your hands.
Door removal
The hinges (A) have two movable bolts on them (B).If you raise both of the mo-
vable bolts (B),then the hinges (A) are released from the oven housing. (see figure).
You should grip the sides of the door at the centre and then incline it slightly
towards the oven cavity and then pull the door gently away from the oven cavity.
IMPORTANT: You should make sure that the door is supported at all times and
that you place the door on some padded material whilst cleaning it. The oven
door and door glass should only be cleaned using a damp cloth and a small
amount of detergent. Don't use any chemical cleaner.
To refit the door you should slide the hinges back into their slots and open the
door fully. The movable bolts (B) must be closed back into their original positions
before closing the door.

Cleaning and Care

26