Samsung NX58M9960P Série Manuel D'installation page 24

Installation instructions
Step 7. Assemble the surface burners
CAUTION
Do not operate the surface burners without all burner parts in place.
Position surface burner heads on top of the surface burner manifolds as
1.
shown at right. The electrodes will fit into the slot in the bottom of the heads.
Make sure the surface burner heads are flat and parallel with the cooktop.
2. Place the matching size caps on top of each surface burner head.
NOTE
The caps on Precise simmer burner (RR) and inside Dual Burner (RF) can be
interchangeably used.
Top
24 English
Install_NX58M9960PS_DG68-01009A-01_EN+MES+CFR.indb 24
Bottom
3. Place the left and right surface burner
grates on the cooktop. The edges of the
grates should match up with the edges
of the cooktop.
NOTE
• Grates should be placed on its
own position because they are not
interchangeable.
• You can recognize the right position
of grate by checking the bottom side
of each grate. Under the right and left
grate, "RIGHT REAR" and "LEFT REAR"
are engraved each.
• The grates are heavy. Be careful while
handling the grates.
Step 8. Check the ignition of surface burners and oven burners
Check the operation of all cooktop and oven burners after the range has been
installed and assembled, gas supply lines have been carefully checked for leaks,
and electrical power cord has been plugged in.
All surface and oven burners have electronic ignition.
To turn on a surface burner:
Ignite the surface burner.
To start the bake and roast burners:
1.
2.
3.
NOTE
To change the temperature during cooking, use the temperature selector knob.
Turn the mode selector knob from OFF
to Bake, Roast, Convection Bake or
Convection Roast.
Rotate the temperature selector knob
from the OFF position to change the
temperature. You can set the oven to
any temperature from LO to 550 °F.
• The gas oven preheats until it
reaches the temperature you set.
• When preheating is complete, place
the food in the gas oven, and then
close the door.
When cooking is complete, rotate both
mode and temperature selector knobs
to the OFF position, and then take out
the food.
2017-12-14 2:40:02