Honeywell Air Caddy 15100 Série Guide D'utilisation page 4

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Controls
Operation
1. Make sure that the control knob is turned
to OFF.
2. Place the filter in the unit. The filter is
packaged separately. For instructions, see
the section Installation/Filter Replacement.
3. Open the bottom panel by placing your
thumb on the plastic tab, pushing toward
the center of the unit, and pulling up.
4. Remove the AC adapter plug that comes
with the unit.
5. Insert the AC power cord into the 12V AC
receptacle inside the unit. See letter D in
the Parts and Assembly section.
6. Slide the cord to the edge of the base and
replace the bottom panel door, making sure
that the power cord fits through one of the
notches indicated.
7. Plug the AC adapter into a grounded 120V
AC receptacle.
8. Turn the Air Caddy on.
Unit is on with filtering photoelectric cell;
as the room darkens, night light will
come on.
Unit is on and filtering with night light
always on.
Unit is on and filtering.
Unit is off.
Plastic Tab
Notches

Publicité

Table des Matières
loading

Table des Matières