Brother P-touch PRO DX Guide De Référence Rapide page 9

When connecting to the USB port:
You must install the software first before connecting to the USB interface or turning on the power. Please follow the
installation procedures on pages 10 through 12 before connecting up or turning the power on. The Brother P-touch
installation software will instruct you when to do this.
1 Connect one end of the enclosed USB interface cable to the USB connector (
end of the cable to the USB port of the computer.
Do not connect the PT-9200DX to the computer using both the serial and the USB interface cables, otherwise
the PT-9200DX may be damaged.
When making a USB connection through a hub, a proper connection may not be possible due to the type of
hub used. If printing is not possible with a hub connection, try connecting the PT-9200DX directly to the
computer using the USB interface cable.
2 Insert the plug on one end of the power supply cord into the power supply jack on the PT-9200DX.
3 Insert the plug on the other end of the power supply cord into an AC outlet equipped with a grounding terminal.
Some locations may require the use of an adapter provided with a grounding wire. Connect this wire to the ground
terminal.
USB
) of the PT-9200DX and the other
5