Removing Your Object - Dremel 3D45 Consignes D'utilisation/De Sécurité

DM 2610047405AB 03-18_3D45 3/27/18 9:51 AM Page 31
REMOVING yOUR OBJECT FROM THE
BUILD PLATFORM
Do not touch the extruder
tip or heated build platform
WARNING
during Dremel 3D45 operation or until it
has cooled down to at least 60°C (140°F).
Contact with the extruder tip or build platform
during or after operation before tip and build
plate has cooled may result in personal injury.
Use personal protective
equipment. The use of
WARNING
protective equipment such as heat resistant
gloves and safety glasses will reduce
personal injuries.
Be aware of your body
position when using hand
WARNING
tools to remove objects from the build
platform. Sudden tool slip and improper
body position during object removal from the
build platform may result in personal injury.
Do not drop the build
platform. Tempered glass
WARNING
plate may break and result in personal injury.
Do not twist or bend the
build
WARNING
removing objects. Tempered glass plate
may separate from plastic holder and result
in personal injury.
Avoid scratching the build
platform when removing
CAUTION
objects. Scratches in the build platform will
result in improper object creation.

Removing your Object

platform while
Removal
Tool
1. Wait for the extruder or build platform to
cool before removing your object.
2. With the object still attached, remove build
platform from the build area.
3. Peel your object from the build platform. If
needed, gently use the object removal tool
to remove object from build platform
(figure 8).
REMOVING SUPPORTS
(IF REQUIRED)
Use needle nose pliers to remove supports
that are inside your object or hard to reach.
31
FIG. 8