Dremel 3D45 Consignes D'utilisation/De Sécurité page 26

DM 2610047405AB 03-18_3D45 3/27/18 9:51 AM Page 26
26
FIG. 3
Tab
Front Clip
PREPARING BUILD PLATFORM
Do not touch the extruder
tip or heated build platform
during Dremel 3D45 operation or until it
has cooled down to at least 60°C (140°F).
Contact with the extruder tip or build platform
during or after operation before tip and build
plate has cooled may result in personal injury.
Do not drop the build
platform. Tempered glass
WARNING
plate may break and result in personal injury.
Do not remove tempered
glass plate from plastic
WARNING
holder. Contacting with tempered glass plate
edge may result in personal injury.
Before every build make
sure that the build platform is
CAUTION
covered with glue from the supplied glue
stick. If glue is not used, it may cause poor
object build quality.
1. Remove build platform by first pressing
down and releasing the two clips located
at the front of the build platform, then lift
the build platform off the base using the
build platform tabs (figure 3).
Getting Ready to Build
Rear Clip Rear Clip
Base Build
Platform
2. Apply the glue in two overlapping layers to
ensure that the entire build surface is
properly covered. You can apply glue to
the perimeter of the build plate first, and
then zigzag up and down while
overlapping the entire area. Wait for 10
seconds and then apply another layer
zigzagging left to right. This ensures a
uniform layer over the entire build area.
FIG. 4
NOTE: To clean the build platform, rinse
the platform with warm water and dry with
a towel.
3. Install the build platform by first inserting
the rear of the platform onto the rear clips,
then press down on the front of the
platform until it snaps in place.
Front Clip
Tempered
Glass
Glue
Stick
Tab