Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Battery storage
_ Store and charge your batteries in cool area.
Temperatures below 10 °C (50 °F) or above
38 °C (100 °F) will shorten battery life.
_ Never store batteries in discharged condition.
Recharge them immediately after they are
discharged.
_ Batteries gradually lose their charge, the higher
the temperature the quicker, so If you store your tool
for longer periods of time without using it, recharge
the batteries every month or two. This will prolong
battery life.
TECHNICAL DATA
Article number
Blade width
Blade
Height of cut
Grass box capacity
Battery GY2201
SAMSUNG
Charging period
Charger GY2211
Charging current
Charger output
Allowable charging
temperature range
Cutting time
Speed
Battery-type and data
Int. protection degree
Weight without battery
Noise emission values measured according to
relevant standard
Sound pressure level
L
77.9 dB(A) K=3 dB(A)
PA
Sound power level
L
90.2 dB(A) K=1.85dB(A)
WA
Guaranteed sound power level
L
94 dB(A)
WA
ATTENTION ! The sound power
pressure may exceed 85 dB(A), in this case
individual hearing protection must be worn.
Weighted root mean square acceleration according
to relevant standard. :
TROUBLESHOOTING
Wear work gloves!
GPTDE40V34-LI
340mm
GT-340
25-65mm
35 L
40V
2000 mAh
1 h
220-240V~50hZ
3 A
42V DC
0 – 50°C
22 min Max
-1
3000 Min
Li-ion
IPX1
9.9 Kg
0.5 m/s
2
K=1,5 m/s
2
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).
SERVICE DEPARTMENT
_ Damaged switches must be replaced by our after-
sales service department.
_ If replacing the power cord is necessary, it
should be done by the manufacturer or his agent
to avoid a hazard.
AFTER-SALES SERVICE AND
APPLICATION SERVICE
Our after-sales service responds to your questions
concerning maintenance and repair of your product
as well as spare parts. Exploded views and
information on spare parts can also be found
under:www.eco-repa.com
GARDEO PRO application service team will gladly
answer questions concerning our products and their
accessories : sav@eco-repa.com
Publicité
Table des Matières
