Use; Drainage; Maintenance And Cleaning - Vortice DEUMIDO 10 EVO Notice D'emploi Et D'entretien

ENGLISH

Use

Fig.2
1) Power indicator
2) ON/OFF (power) button
3) "Full Water" indicator
4) Humidity setting button
5) Working mode indicator (continuous working, humidity 40%, 50%, 60%, 70%)
6) Timer operation indicator
7) Timer button
• Plug the unit into a correct mains socket. (Please refer to the rating label at the rear of the unit for correct
voltage/frequency.)
• Press ON/OFF button to turn on the unit. The power indicator will light on and the compressor will start to work.
• Press humidity setting button to set the working model you need: continuous working, humidity 40%, 50%, 60%
or 70%. The relative indicator will light on.
• Press the TIMER button to set the operating hour you need. There are 4 hour indicators above the TIMER
button: 1, 2, 4, 8H, however, the working house could be accumulated, so it's not just 4 different hours you
could set. For example, choose 1 and 2 hours at the same time, the unit will work 3 hours continuously,
choose 1, 2 and 4hours at the same, it will work 7hours. Thus, the max. working hours you could set is
15hours, in case all these 4 hour indicators light on . As the set time has been reached, the compressor will
stop working automatically.
• To turn off the unit, press ON/OFF button again.
• AUTO-RESTART function: in the event of temporary suspension of the power supply, the device resumes
operation while maintaining the previously programmed settings when power is restored.
• Pre-setting function By pressing TIMER button but without turning on the other functions (including ON/OFF
button), you can PRE-SET the time for the machine to work. For example, if you press the timer to 2H, the
unit will work automatically after 2 hours.
• When the water tank is full, the "Full Water" indicator will light on for alarm, an audible alarm will sound and
the compressor will stop for self-protection.

Drainage

While the water tank is full, the compressor will stop for self-protection and the water full indicator will turn red.
To move the water tank, pull it out squarely from the unit.
After empting the water tank, place the water tank into space. Make sure it is properly positioned, in order for the
'water full' sign to go out and your dehumidifier is operating.
Note: in case, the water tank has not been positioned well, the water full indicator will turn red.
Continuos drainage
When the dehumidifier is operated at very high humidity levels, the water tank will require more frequent drainage.
In this situation, it may be more convenient to set the unit up for continuous drainage with the following procedu-
res:
• Connect the spout for continuous drainage with water tube of inner diameter: 11 mm. The water tube is not
supplied with the unit.
• Ensure the water will always drain away freely and the tube will remain in right place.
Note! In very cold weather conditions, precautions should be taken to prevent the water tube from freeing.
Fig.3
a) Spout for continuos drainage
b) Water tube of inner diameter 11 mm

Maintenance and cleaning

Always unplug the unit from the mains before carrying out any maintenance or cleaning of the unit.
CLEANING THE BODY
Use soft cloth to wipe the unit clean.
Don't ever use volatile chemicals, gasoline, detergents, chemically treated clothes, or other cleansing solutions.
These all could possibly hurt the cabinet.
22