RIDGID RP 350 Manuel page 8

RP 350/RP 351 Press Tools
Control Marking
On/Off Button
Run Switch
Pressure
Release Button
Attachment
Mounting Pin
Figure 4 – Controls Chart
1
2
3
4
Figure 5 – Tool Status Lights
6
Description
Main tool power switch. (I = ON, O = OFF).
ON: Press button until light turns ON. See Figure 5 – Tool Status Lights.
OFF: Press button until light turns OFF. Tool will automatically turn OFF if left unused for ten
(10) minutes.
Turn On Work Light: slightly depress run switch.
—
Normal Mode: Depress run switch to start press cycle, release when tool locks on. Normal
mode is factory setting.
Control Mode: Depress run switch to engage attachment on workpiece. Make adjustments
as necessary. Press the run switch again to start press cycle, release when tool locks on.
Releasing the switch will not stop the tool once it has locked on. This assures consistent,
repeatable press connection integrity.
Mode can be changed with RIDGID Link App, see Bluetooth Functions section.
Allows tool to be released without completing press. If used, press connection is not complete
and must be repeated.
— Holds attachment to tool. Must be fully inserted for tool to operate. See Figure 6.
Light Segment Number
(Light Continuously On)
1 3
2
— — —
Green Green Green
Blue Blue Blue
Green — —
Red Yellow Yellow
Red — —
Yellow — Red
Yellow — —
Yellow Red —
Green Blue Blue
Purple
Description
4
— Press tool off (OFF).
Green ON button pressed, lights on 4 seconds at start up, tool in "Normal
Mode".
ON button pressed, lights on 4 seconds at start up, tool in "Control
Blue
Mode" - see Bluetooth Functions section to change mode.
— Press tool is in Normal Mode, standby, press tool ready to operate.
Tool has malfunctioned. Tool will not operate. Remove and reinsert
Yellow
battery or AC Adapter. If light still on, have tool serviced.
Tool has malfunctioned. Tool will not operate. Remove and reinsert
—
battery or AC Adapter. If red light still on, have tool serviced.
Tool and/or battery out of Specification temperature range. Tool will
Red
not operate. Bring the tool and battery to correct operating temper-
ature range.
Attachment mounting pin is not fully inserted. Tool will not operate.
Red
Fully insert pin. If lights still on, have tool serviced.
Battery low. Tool will not operate. Recharge battery/Insert fully
—
charged battery.
Bluetooth connection established, standby, press tool ready to
Blue
operate - For further information see section on Bluetooth
Functions.
Firmware update in process, tool cannot be used while updating.
999-995-220.10_REV. B