DSM Delvotest Fast Start III Manuel D'utilisation page 4

EN
Delvotest
Operation Manual
Version 1.0
Introduction
Thank you for purchasing our products: Delvotest
operation of the incubator, In order to use the instrument properly, please read this manual carefully before use.
The Delvotest Fast Start incubator is designed to be used with Delvotest
®
Opening Check
Please check the instrument and adaptor when you first open the packing case. If you find something wrong with the instrument
and/or adaptor, contact your local DSM representative.
Package contents
No.
1
2
3
Safety Precautions
• Read the user manual carefully before operation.
• This product is for indoor use on a levelled surface.
• The metal block heats up during use, do not touch to avoid injuries.
• The operator should not open or repair the instrument. Contact your local DSM representative for assistance.
• The instrument should be used in a location where the temperature is between 5°C (40° F) and 35°C (100° F), it should not be
placed near an open window or in direct sunlight. The place should not contain gas or be near a strong disturbing magnetic field.
Do not put the instrument in a wet and /or dusty place. The incubator should not be used in a room where antibiotic drugs are
stored.
• Power off when you finish your work. Pull out the connector plug when the instrument will not used for long time and prevent
dust by storing accordingly.
Cleaning Instructions
Power off when cleaning incubator. If the instrument gets dirty, clean it with a dry cloth, the metal block should be cleaned regularly
with a dry cloth or tissue. Do not use water or any other liquids.
Operating guide
Installing the device
1 Place the incubator on a horizontal surface.
2 Insert the 12V connector of the adapter into the power connec-
tor on the back of the device, and connect the other side of the
adapter to the main power supply of 100~240V.
3 Turn on the power switch of the device, incubator will start to
heat up to the set temperature if preheat function is on.
The heating time usually takes 10-15min. See point 4.2.2.
pre-heating function.
4 Once device reaches to the target temperature, Ready will ap-
pear on the top-left of the screen with one beep.
Keyboard functions
1 Set---Press to set the temperature, preheat and time.
2 "▴" and "▾"---modify the parameters to set.
3 Enter---Save the modified value.
4 A Timer / B Timer / C Timer---Short press to start time counting,
long press 5 seconds to stop counting. During time counting,
press to pause and press again to continue counting.
Parameter setting
1 Press "Set" to enter parameter setting interface. Press "Set" to
shift the setting item, press "▴" or "▾" to set parameter value.
2 After setting, press "Enter" to save and go back to the main in-
terface. In case of no operation in 10 seconds, device will save
the latest value inserted and go back to the main interface
automatically.
Fast Start III
®
Fast Start III. This manual for users contains information and instructions for
®
Item
Incubator
Adapter
Manual
Fast range of test for antibiotic residue detection in milk.
®
Type
Delvotest Fast Start
®
DC12V 5A
QTY
1
1
1
Display
Panel
Power switch
Block
Power i nput
port